English
A center winding dual station fully automatic cutting and winding machine. Involving film blowing machines. Non woven fabric. Fabric. TPU material. Paper. Cast sheet material. Printing equipment. Composite equipment. Coating equipment. Domain.
The advantage of this structure is the use of a dual station axle changing structure. Independent control. It can be flipped 360 degrees in both directions. Can be equipped with a torque motor. Servo motor. Three phase asynchronous motor. There is a cutting device driven by a rodless cylinder to fly the blade. Reach the material setting in meters. Automatic cutting function. Can synchronize with the main device. Replace the waste generated by manual roll replacement. Equipped with a preloading device. Can solve the extreme rebound caused by sheet rewinding.
The process is as follows. S1- Install two side wall panels from the base. And dual station drive AB two motors. S2- Install flip brackets on both sides of the wall panels. Driven by a turbine toothed disc. The motor drives 360 bidirectional rotation. Install 2 cross wall panels on the central axis of the S3 flip frame. There are two symmetrical inflatable shaft mounting seats at 45 degrees each. Driven by a sprocket. Install two rotary bearing seat sprockets on one side of the flip shaft. Separate from the flipping axis. Two guiding aluminum rods are installed symmetrically at a 90 degree angle. S4- The pneumatic shaft transmission end is equipped with a cylinder clutch. Switch between dual workstations according to process requirements. S6- Located directly in front of the base. Straight track. Install a rubber stick. When changing rolls. The flipping frame stops here. The cylinder pushes the rubber stick closer to the inflation axis. S7- The cutting tool holder is controlled by a cylinder. Press down to the cutting position. S8- The flying knife holder is controlled by a cylinder - it is pressed down to the rubber stick position during cutting. S9 rodless cylinder is installed on the inside of the flying knife holder. During cutting, the air path is controlled by an electromagnetic valve to run horizontally on both sides. Install sheet metal covers on both sides of the S10 outer wall panels. Install industrial electrical components.
